+86-512-5630-3759
+86-19962650268
SPC Tiles Production Line also called hard PVC floor production line, which is a product first extruded the PVC substrate by conical twin-screw extruder, then laminate the PVC pattern film, PVC wearing layer and PVC basement film the same time by 4-roller press machine.
About conical twin-screw extruder, you can visit: http://jz.md9119.com/conical-twin-screw-extruder/
| NO. | Machine Name | Qty. |
| 1 | SJSZ92/188 Conical twin screw extruder | 1 set |
| 2 | Hanger plate mold | 1 set |
| 3 | Four-roll calender | 1 set |
| 4 | Cooling bracket + trimming device | 1 set |
| 5 | Four-site coating + correction device | 1 set |
| 6 | Traction machine | 1 set |
| 7 | Precision cutting plate machine | 1 set |
| 8 | Feeding device | 1 set |
The spc tiles production line is simple, and the laminating is completed by heat, no need glue.
The density of SPC floor: 1.9~2t/cbm.
The shrinkage of SPC floor: ≤1‰（after tempering） ≤2.5‰（without tempering）
(Shrinkage test standard: 80℃, 6 hours)
| 1 | Use raw materials | PVC plus accessories |
| 2 | Production line speed | 0-6m / min |
| 3 | Maximum yield | 600-800kg / h |
| 4 | Total installed power | 200kw |
| 5 | Actual energy consumption | 140kw |
| 6 | Air consumption | 0.4m3 / min |
| 7 | Air pressure | 0.6mpa |
| 8 | Water circulation | 0.3m3 / min |
| 9 | Working temperature | 0-40 ° C |
Advantages of SPC tiles: SPC tiles are stable and reliable, Chemical indicators meet international standards.
Disadvantages of SPC tiles: SPC tiles are heavy in weight, so the transportation cost is high.
1.Q:How to solve the problem about material leakage of high mixer quickly?
A:Replace the seal gasket or check the cylinder distance whether it is enough .
2,Q:why the low-mixer is always burned?
A:The mixture exceeds the rated capacity, causing the motor to overload.
3,Q:How to adjust the space of the screw?
A:Log in Polytech official website, www.polytech.net.cn, authorized to download the video tutorial.
4,Q:How to solve the the ASA coating problem?
A:Many reasons ,such as temperature, formulation, start-up speed etc.
5,Q:Why the material Burnt?
A:Many reasons, such as high heating temperature, heating preservation time is too long.
6, Q:Why the ASA is covering on the bottom?
A:Many reasons ,such as temperature, formulation, start-up speed does not match.
7, Q:Asymmetrical ASA2/4 area covering?
A:Many reasons ,such as temperature, formulation, start-up speed does not match.
8,Q:How to adjust the dislocation of glazed tile module?
A:By adjusting tooth on the dynamic column to achieve the right location of module.
9, Q:Why Shaping mould two side speed is not synchronization?
A:Two side shaping module is not synchronized.
10,Q:Why the Cutter machine does not move?
A:Replace the sliding bearing seat under rack or moving cylinder.
Copyright 2018 Wuxi Guangliang Plastic Machinery Co., Ltd
